Phenom | Kingz | Dabatos | TonySelf | Tha Q | Half Breed | Tito | 7th End | RV Radio |
11-15-05, 07:03 PM | #1 | |||||||
New to RV
|
Cool Edit HELP
IP: BF59 CAC9
So I record my vocals, but i can only hear it out of one speaker. How do i split the waveform so i hear it out of both???? thanks
__________________
THE LYRICAL MIRACLE |
|||||||
11-15-05, 08:26 PM | #2 | ||||
O.wning Y.ou D.aily
|
IP: C4C6 CFF1
First, check your speaker connection to make sure they are plugged in correctly. If they are, and you can still only hear out of one side, go to the single track mode by clicking the little thing in the top left hand corner right under the word FILE. Once in single track go to EDIT>>Convert Sample Type. While in there, convert your file to Stereo and make sure the button for 32 BIT is pressed instead of 16 BIT. Also, make sure that you split the ratio from right to left up by placing 50 in each of the spots that have numbers in them......I hope this helps ™
__________________
|
||||
11-15-05, 11:31 PM | #3 | |||||||
New to RV
|
IP: BF59 CAC9
oooo ic. My tracks were all in mono. Thanks a lot. Is there a way to preset the stereo, so i don't have to change it everytime?
__________________
THE LYRICAL MIRACLE |
|||||||
11-16-05, 01:35 PM | #4 | ||||
O.wning Y.ou D.aily
|
IP: D573 CA2C
Actually, if you record in mono, then do some of your editing before you change it to stereo, it helps with the quality, but if you're too lazy to do all that, just go to OPTIONS>>Settings and change it to stereo and 32 Bit ™
__________________
|
||||
Thread Tools | Search this Thread |
Display Modes | |
|
|